Water Filter; Installing The Filter - DèLonghi Magnifica S Cappuccino ECAM25462 Get Started

WATER FILTER

Installing the filter

1. Remove the filter from packaging.
2. Turn the date indicator disk
(A) until the next 2 months of
use are displayed.
3. To activate the filter, put it
under tap water until water
overflows the side openings
for more than 1 minute (min.
500 ml) (B).
4. Remove the water tank from
the appliance and fill with
water.
5. Insert the filter in the water
tank and immerse it completely
for ten or so seconds, sloping
it to enable the air bubbles to
escape (C).
6. Insert the filter in the filter housing
press as far as it will go.
7. Close the tank with the lid (E), then place
the tank in the machine. When you
install the filter, you must notify the
appliance of its presence.
A B
Please note! The filter lasts about two months if the appliance is used normally. If the espresso maker is
left unused with the filter installed, it will last a maximum of three weeks.
12
(D) and
Please note:
It may happen that a single hot water is not sufficient
to install the filter. The following message appears:
"GROUND TOO FINE ADJUST MILL" In this case,
repeat the installing operation. The new filter is active
and you can now use the coffee maker.
C
8. Press the
button to enter the
menu.
9. Turn the dial until the "Installed
Filter" is displayed.
10. Press the
button to confirm
the selection.
11. The message "ENABLE?" is
displayed.
12. Press the
button to confirm
the selection. "Hot Water
Confirm?" is displayed.
13. Press the
button to confirm
the selection.
14. After delivery, the appliance
returns automatically to the
"Ready for Coffee" position. The
new filter is active. You can now
use the coffee maker.
D E