Connect Control Cable; Connect Speakers - Philips dcd8000 User Manual

Connect control cable

• Connect the control cable connector
from the back of the DVD unit to the
CONTROL CABLE jack on the back of
the amplifier.

Connect speakers

Note
•
Insert the stripped portion of each speaker
wire into the socket completely.
•
For optimal sound, use the supplied speakers
only.
•
Connect only speakers with impedance that is
the same or higher than the supplied speakers.
•
The DEMO jack is only applicable to the demo
unit that is not included in the apparatus. Do
not attempt to connect any other device to
the apparatus through this jack.
12 EN
For the main unit side:
2
1
3
1
Unscrew the speaker connectors.
2
Insert fully the red end of a speaker cable
into the left red (+) connector.
3
Screw the left red (+) connector to
secure the cable.
4
Insert fully the silver end of a speaker
cable into the left black (-) connector.
5
Screw the left black (-) connector to
secure the cable.
6
Repeat steps 2-5 to insert the other
speaker cable into the right connectors.
For the speaker side:
1
Unscrew the speaker connectors.
2
For the left speaker, identify the speaker
cable that is connected to the left
connectors on the main unit.
3
Insert fully the red end of the speaker
cable into the red (+) connector.
4
Screw the red (+) connector to secure
the cable.
5
Insert fully the silver end of the speaker
cable into the black (-) connector.
6
Screw the black (-) connector to secure
the cable.
7
Repeat steps 2-6 for the right speaker.