Step 2: Connecting Speakers; Step 3: Connecting The Control Cable; Step 4: Connecting - Philips MCD709/93 User Manual

Step 2: Connecting speakers

1
Connect the speaker wires to the
SPEAKERS terminals, right speaker to "R"
and left speaker to "L", coloured (marked)
wire to "+" and black (unmarked) wire to
"–". Fully insert the stripped portion of the
speaker wire into the terminal as shown.
1
2
Connect the passive subwoofer to the
SUBWOOFER terminal with the supplied
subwoofer cable by matching the plug
types.
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Step 3: Connecting the control
cable
●
Connect the serial port marked "CONTROL
CABLE" at the rear of the DVD player to the
same port at the rear of the power amplifier
with the supplied flat control cable.
2
1
2
Connections
Step 4: Connecting TV
IMPORTANT!
– You only need to make one video
connection from the following options,
depending on the capabilities of your TV.
– Connect the DVD system directly to
the TV.
Using Composite Video jack
2
1
Use the composite video connectors (yellow) of
the supplied audio and composite video cables
(2-in1) to connect the DVD system's VIDEO
OUT jack to the video input jack (or labeled as
A/ V In, CVBS, Composite or Baseband) on the
TV.
To hear the TV channels through this DVD
system, use the audio connectors (white/ red) of
the supplied audio and composite video cables
(2-in1) to connect AUDIO IN jacks to the
corresponding AUDIO OUT jacks on the TV.
LINE OUT
SUB WOOFER
43