North Star M110800F.4 Owner's Manual page 63

Step 17 – Valve Installation Continued
 Remove plugs from ports in control valve
 Lubricate O-ring and threads on fitting with clean oil
 Looking at fitting from end with nut/washer/O-ring assembly, turn nut
clockwise as far as possible
 Using wrench, turn (1) Valve to Hydraulic Pump Fitting into valve port
marked "IN" until washer touches control valve. Continue turning until
washer touches thread nearest wrench pad
 Back off fitting counterclockwise not exceeding one revolution until it
is oriented in the correct position
 Place wrench on the wrench pad of fitting to prevent fitting from
turning and torque nut to 70-87 ft.-lb.
Fitting Orientation
45°
Assembly Instructions
Hydraulic Pump Fitting
63
Tools Needed
 7/8" Wrench
 1" Wrench
OR
 Crescent Wrench
(2 needed)
 Torque Wrench