Step 8 – Suction Hose from Tank to Pump
In step 6, a piece of suction hose was installed to the fitting on the
hydraulic tank assembly.
Locate the other end of the suction hose and the hydraulic pump as
show below.
Loosen hose clamp as necessary. Slide hose clamp onto end of suction
hose and push onto pump fitting.
Secure and tighten hose clamp around the suction hose and pump
fitting. Torque to 78 in.-lb.
Hose clamp must have a tight seal to prevent hydraulic oil from
leaking.
Fasteners Needed from Parts Bag:
Tank to Pump Hose Clamp
Qty 1
110900 and 1131 Only
Assembly Instructions
Tank to Pump Hose Clamp
Qty 1
110800 Only
Suction Hose
Hose
Clamp
Pump Fitting
50
Tools Needed
Flat Blade Screw
Driver
Torque Wrench
Hydraulic Pump