Download  Print this page

Makita LS0714 Instruction Manual page 19

Slide compound saw
Hide thumbs

Advertisement

Adjusting the position of laser line
For model LS0714FL, LS0714L
1
2
3
005701
1
2
005702
WARNING:
As the tool is plugged when adjusting the position
of laser line, take a full caution especially at switch
action. Pulling the switch trigger accidentally cause
an accidental start of the tool and personal injury.
CAUTION:
Never look into the laser beam directly. Direct laser
beam causes damage to your eyes.
Never apply a blow or impact to the tool. A blow or
impact causes the incorrect position of laser line,
damage to the laser beam emitting part or a short
life of the tool.
Have the tool repaired by Makita authorized service
center for any failure on the laser unit. No change
with different type of laser is permitted.
When adjusting the laser line appears on the left
side of the saw blade
1
1. Screw to change the movable range of the adjusting
screw
2. Adjusting screw
3. Hex wrench
4. Laser line
5. Saw blade
005527
1. Workpiece
2. Cutting line
3. Holder
assembly
(optional
accessory)
1. Vertical vise
2. Holder
assembly
(optional
accessory)
2
4
3
When adjusting the laser line appears on the right
side of the saw blade
1
1. Screw to change the movable range of the adjusting
screw
2. Saw blade
3. Laser line
005528
For both adjustments, do as follows.
1.
Make sure that the tool is unplugged.
2.
Draw the cutting line on the workpiece and place it
on the turn table. At this time, do not secure the
workpiece with a vise or similar securing device.
3.
Lower the blade by lowering the handle and just
check to see where the cutting line and the
position of the saw blade is. (Decide which
position to cut on the line of cut.)
4.
After decision the position to be cut, return the
handle to the original position. Secure the
workpiece with the vertical vise without shifting the
workpiece from the pre-checked position.
5.
Plug the tool and turn on the laser switch.
6.
Adjust the position of laser line as follows.
The position of laser line can be changed as the movable
range of the adjusting screw for the laser is changed by
turning two screws with a hex wrench. (The movable
range of laser line is factory adjusted within 1 mm from
the side surface of blade.)
To shift the laser line movable range further away from
the side surface of blade, turn the two screws
counterclockwise after loosening the adjusting screw.
Turn these two screws clockwise to shift it closer to the
side surface of the blade after loosening the adjusting
screw.
Refer to the section titled "Laser line action" and adjust
5
the adjusting screw so that the cutting line on your
workpiece is aligned with the laser line.
NOTE:
Check the position of laser line regularly for
accuracy .
Have the tool repaired by Makita authorized service
center for any failure on the laser unit.
19
2
3

Advertisement

loading

  Related Manuals for Makita LS0714

This manual is also suitable for:

Ls0714fLs0714flLs0714l