The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
The typical A-weighted noise level determined according
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
The vibration total value (tri-axial vector sum) determined
according to EN61029:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
) : 92 dB(A)
) : 101 dB(A)
) : 2.5 m/s
For European countries only
EC Declaration of Conformity
manufacturer declare that the following Makita
Designation of Machine:
Slide Compound Saw
Model No./ Type: LS0714, LS0714F, LS0714FL, LS0714L
are of series production and
Conforms to the following European Directives:
And are manufactured in accordance with the following
standards or standardised documents:
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd.
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
Anjo, Aichi, 446-8502, JAPAN
WARNING! When using electric tools, basic safety
precautions, including the following, should always
be followed to reduce the risk of fire, electric shock
and personal injury. Read all these instructions
before operating this product and save these
For safe operations:
Keep work area clean.
Cluttered areas and benches invite injuries.
Consider work area environment.
Do not expose power tools to rain. Do not use
power tools in damp or wet locations. Keep work
area well lit. Do not use power tools where there is
risk to cause fire or explosion.
Guard against electric shock.
Avoid body contact with earthed or grounded
30. 1. 2009