Rack Mounting - Sony MSW-A2000 Installation Manual

1-6. Rack Mounting

1-6. Rack Mounting
Explains how to mount this unit into a 19-inch standard
rack.
Be sure to mount this unit into a rack accurately following
the procedure and notes mentioned below.
c
. Use the specified rack mount rail.
The use of other rail of low strength may drop the unit
and cause the risk of injury.
. To prevent toppling over the rack, fix it on the horizontal
and firm floor securely with bolts, etc.
. Mount the unit into a rack with a steady posture.
m
. When other equipment with built-in hard disk drive is
already mounted in the same rack for mounting this unit,
turn off the power of the equipment before mounting this
unit.
. Connect long enough cables on the connector panel,
considering that the unit is pulled out from the rack.
. Do not operate this unit without the upper lid and bottom
plate except when servicing it.
. Adjust the temperature inside the rack within the range
of the unit's operating temperature.
(Refer to Section 1-3.)
Specified Rack Mount Kit
RMM-130 (Optional accessory)
n
When mounting this unit into Sony LMS (Library Manage-
ment System) VTR console, it is necessary to modify the
VTR console.
1-4
Parts Packed in RMM-130
. Slide rails ......................................... 2
. Rack angles (handles) ..................... 2
. Rail brackets .................................... 4
. Plate nuts (large) ............................. 4
. Plate nuts (small) ............................. 4
. Screws (PSW4 x 16) ...................... 4
. Screws (B4 x 8) .............................. 8
. Hexagon socket head cap screws .... 8
. Flat washers ..................................... 8
. Screws (RK5 x 14) ......................... 2
. Ornamental washers ........................ 2
. L-shaped hexagon wrench .............. 1
Rack Mounting Procedure
. Removing the feet
1. Set the unit its side panel down.
2. Unscrew the four screws to remove the feet from the
bottom plate of the unit.
3. Set the unit in a horizontal position.
Foot
PS4 x 20
n
Keep these screws and the feet.
When operating the unit after demounting it from the rack,
be sure to reattach the feet.
Tightening torque: 98 x 10 _2
Foot
PS4 x 20
N . m {10 kgf . cm}
MSW-A2000
MSW-A2000P