Rack Mounting - Sony SRW-5800 Installation Manual

1-6. Rack Mounting

Explains how to mount this unit into a 19-inch standard
rack.
Be sure to mount this unit into a rack accurately following
the procedure and notes mentioned below.
w
. To prevent toppling over the rack, fix it on the horizontal
and firm floor securely with bolts, etc.
. When installing the unit in an Outside Broadcasting van,
be sure to fix the unit to the rack using the screws and
ornamental washers supplied with the rack mount kit.
c
. Use the specified rack mount rail.
The use of other rail of low strength may drop the unit
and cause the risk of injury.
. Mount the unit into a rack with a steady posture.
m
. When other equipment with built-in hard disk drive is
already mounted in the same rack for mounting this unit,
turn off the power of the equipment before mounting this
unit.
. Connect long enough cables on the connector panel,
considering that the unit is pulled out from the rack.
. Do not operate this unit without the upper lid and bottom
plate except when servicing it.
. To reduce an increase in the internal temperature of this
unit, keep the following space away from walls.
Right, Left: 4 cm (1.6 inches) or more
Rear: 10 cm (4 inches) or more
. Adjust the temperature inside the rack within the range
of the unit's operating temperature.
(Refer to Section 1-3.)
1-4 (E)
Specified Rack Mount Kit
RMM-110 (Optional accessory) or
RMM-111 (Optional accessory)
The color of rack angle of RMM-110 fits to the unit.
RMM-111 is the same consistency, strength and dimension
as RMM-110, but the color of rack angle is different.
m
. When mounting this unit into Sony LMS (Library
Management System) VTR console, it is necessary to
modify the VTR console.
. When mounting this unit into Flexicart, be sure to use
the specified kit below.
VTR Mounting Kit: BKFC-53/3
Parts Packed in RMM-110/111
. Slide rails ......................................... 2
. Rack angles (handles) ..................... 2
. Rail brackets .................................... 4
. Plate nuts (large) ............................. 4
. Plate nuts (small) ............................. 4
. Screws (PSW4 x 16) ...................... 4
. Screws (B4 x 8) .............................. 8
. Hexagon socket head cap screws .... 8
. Flat washers ..................................... 8
. Screws (RK5 x 14) ......................... 2
. Ornamental washers ........................ 2
. L-shaped hexagon wrench .............. 1
SRW-5800