Camera - Abus TVIP21502 User Manual

6.2 Camera

General
Rotate image:
Video clip format:
Flip:
Reverse:
Flip + reverse:
IR Cut Filter Mode: Settings for the swiveled IR-cut filter (ICR)
ICR Cut Filter Switch Delay: Switching from day to night mode can be delayed by up to 10 seconds.
IR Cut Filter Threshold:
IR Mode:
Microphone input gain:
Audio Codec:
Host name:
Status LED:
Settings for image orientation
Choose between MPEG-4 and H.264 for the compression of the saved video clips (e.g.
for sending a video clip via SMTP e-mail). The H.264 option can result in the utilization
of more system resources, which can lead to a reduction in camera performance (e.g.
frame rate and motion detection).
The picture is displayed rotated by 180°.
The picture is displayed in mirror reverse.
Select this option if the camera was installed upside down.
Auto: The cut filter swivels in or out automatically according to the light sensor. The
"Threshold" option specifies the switching values.
Night mode: The swivel filter is constantly separated from the image sensor. The image
sensor can record visible light and IR light.
Day mode: The swivel filter is constantly in front of the image sensor. The image
sensor can only record visible light.
Schedule: The swivel filter is switched according to a schedule. The "ICR schedule"
option appears (for details on configuration, see 6.11, "Schedule").
Bright (H) – The higher the value, the earlier the camera deactivates the IR-
cut filter / the IR light.
Dark (L) – The lower the value, the earlier the camera activates the IR-cut
filter / the IR light.
Auto: The IR-LEDs are automatically activated or deactivated based on the limits of
the threshold value setting.
On: IR-LEDs are constantly activated.
Off: The IR-LEDs are constantly deactivated.
The input gain can be setup in 9 steps. By this the mic sensitivity can be
adjusted. The microphone can be deactivated here as well (Mute).
Please select one option g.711_µ-law, g.711_a-law or AM. To record audio over ABUS
VMS software please use g.711.
Enter the network host name here: the max. length is 32 characters.
Switches all status LEDs on or off.
88