AKG DMM14 U Reference Manual page 125

operAting the Device
DMM14 MANUAL
Step Description
3 Keep both rotary knobs pressed down (approx. 4 seconds)
until an acoustic signal is sounded (beep) and the affected
LED rings flash once briefly.
•
The copying process is applied to all rotary knobs that located between the
two selected knobs.
8.12.2 Copying all values
To copy all values from one channel to one or more other channels, proceed
as follows:
Step Description
1 Press the rotary knob with the values to be copied, then
straight away press the rotary knob up to which the copy
process is to be carried out
2 Keep both rotary knobs pressed down (approx. 8 seconds)
until an acoustic signal is sounded (beep beep) and the affect-
ed LED rings flash once briefly.
•
The copy process is possible in both directions (IN 1 to IN 12 and IN 12 to
IN 1).
The following diagrams visualize the copy processs.
8
ON PEAK
IN 1
Figure 53: Select rotary knobs (source)
Value was transmitted to the selected channels.
Values were transmitted to the selected channels.
8 8
ON PEAK ON PEAK
IN 2 IN 3 ...
8 8
ON PEAK ON PEAK
IN 10 IN 11
8
ON PEAK
IN 12
125