AKG DMM14 U Reference Manual page 116

operAting the Device
DMM14 MANUAL
Step Description
1 Press the slider switch and gain control on the rear of the
DMM14 U (UL, ULD)
•
•
•
•
•
2 Switch on the device with the main power switch
Caution: Risk of damage
When using wireless microphones, switch off the phantom power on the in-
puts where you have connected a receiver to avoid damage to the receiver.
8.3 Monitoring the inputs/outputs
To monitor the inputs and outputs, proceed as follows:
Step Description
Hold down the HEADPHONE rotary knob and press to select
1
one or more monitoring source rotary knob
•
2 Change monitoring source by pressing on another monitoring
source.
•
With inputs, multiple sources can be monitored.
The output can be monitored individually and in stereo.
Select the amplification of the input signals between 0 dB
and +57 dB.
Higher amplification of the input signals is suitable for
microphones with a low output level.
Lower amplification is recommended for microphones with
a high output level.
If you are using capacitor microphones, determine which
supply voltage or supply devices these require.
If your capacitor microphones are suitable for phantom
power, switch the phantom power on. To do this, switch
the PHANT. PWR slider switch to ON.
They are switched in mono simultaneously to the left and
right headphone channel.
The previous monitoring source is switched off.
116