Casio EX-ZR3600 User Manual page 72

8.
Press the shutter button to start recording.
• Shooting is repeated at the interval specified in
step 6.
• Recording stops when the recording time specified
in step 6 elapses or when the shutter button is
pressed again.
NOTE
• The monitor screen is blank while a time lapse operation is in progress. The
camera's back lamp will be lit to indicate that recording is in progress. Performing a
camera operation while the monitor screen is blank will cause screen contents to
appear. Note, however, that changing the mode dial setting will cause the Interval
Shot operation to stop.
• If the " Interval" setting is one minute or greater, the camera's lens will retract
and the back lamp will go out between shots. Pressing [ON/OFF] (Power) while an
Interval Shot operation is in progress will cause a message to appear.
The camera's battery can be charged over a USB connection while the lens is
retracted during Interval Shot. If you want the battery to be charged during Interval
Shot, set up the USB connection before starting the recording operation.
Connecting the USB cable while the lens is extended will cause camera power to
turn off.
• The "Auto Flash" and "Red Eye Reduction" flash settings are not supported while a
setting other than "Auto" is selected for the "Aperture" or "Shutter Speed" setting
while using Interval Shot. Selecting Interval Shot while an unsupported flash setting
is in effect will cause the flash mode setting to change automatically to "Flash Off".
• The functions below cannot be used with this function.
Shoot with phone, High Speed CS, Motion Shutter, Anti-shake Functions, Zoom
(SR), Continuous AF, Face Detection, MF (Manual Focus)
• Pressing the shutter button during standby between interval shots (while the
monitor screen is on) will cause "Interval recording was canceled." to appear, and
the interval operation will be canceled.
• The Auto Power Off is disabled while shooting with this function (page 191).
72
Remaining
shooting time
Snapshot Tutorial