Technical Data - WAGNER DTS 5800 Operating Instructions Manual

DTS 5800
Avoid damage! When working in the vicinity of wood / gypsum bases and coated materials
these can be impaired by heat or steam. Remedy: Use a heat / steam shield made of
cardboard or metal. The unit switches off automatically in case of overheating. After
approx.12 minutes, the unit switches itself back on automatically.
The steam time is approximately 120 minutes. Never leave a unit unattended that is on.
Keep the unit away from children and animals. Never let the container steam until it is
completely empty.
Before loosening the screw connections always allow the unit cool down
for at least 2 minutes. Caution! Risk of scalding!
Heated water can leak from the steam plate during the heating-up phase. Hot
water can drip during overhead work.
Descaling
Regular descaling is key to your steamer functioning properly.
i
Depending on water hardness, descale the steam wallpaper remover
after 10 – 15 fills.
Devices which are defective due to a lack of descaling are excluded
from the warranty!
•
Use a standard descaling agent (e.g. household vinegar).
Observe the manufacturer's instructions for use!
•
Mix the vinegar with water (ratio 1:1).
•
Fill the steam wallpaper remover with around 4 litres of descaling solution.
•
Switch the steam wallpaper remover on for around 5 minutes.
•
Switch off the steam wallpaper remover and leave the descaling solution to work for
around 10 minutes.
•
Repeat the above process again.
•
Fully empty the steam wallpaper remover.
•
Thoroughly rinse the device two to three times with clear water to remove all descaling
solution residue.
Storage
Store emptied, upright and dry.

Technical data

Power source:
Steaming time:
Reservoir capacity:
Weight of the steam plate:
230 V ~ Power consumption:
max. 120 min. Steaming power:
5.8 l Hose length:
310 g
GB
2000 W
50 g/min.
3.5 m
9