Get Started; Install The Car Audio - Philips cem1100 User Manual

/
c
Tune to a radio station
Skip track.
Fast backward/forward playback
d SOURCE
Select audio source.
e EQ
Select equalizer (EQ) settings.
f OFF / /
Turn the unit on or off.
Mute or restore volume.

3 Get started

Caution
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.

Install the car audio

These instructions are for a typical installation.
However, if your car has different requirements,
make the corresponding adjustment. If you have
any questions regarding installation kits, consult
your car audio dealer.
Caution
This unit is designed for negative ground (earth) 12 V
DC operation only.
Always install this unit in the car dashboard. Other
locations can be dangerous as the rear of the unit heats
up during use.
To avoid short-circuit: before you connect, ensure that
the ignition is off.
Ensure that you connect the yellow and red power
supply leads after all other leads are connected.
Ensure that all loose leads are insulated with electrical
tape.
Ensure that the leads do not get caught under screws
orin parts that will move (e.g. seat rail).
Ensure that all ground (earth) leads are run to a
common ground (earth) point.
Use only the supplied mounting hardware for a safe
and secure installation.
need to change the fuse, consult a professional.
Note on the power supply lead (yellow)
When you connect other devices to
this apparatus, ensure that the rating
of the car circuit is higher than the
total fuse value of all the connected
devices.
EN
9