Network Camera Setup; Resetting To The Factory Default Settings - Revo REHVDPTZ12-1 Quick Installation Manual

Elite hd 12x full-hd mini-ptz network camera

Hide thumbs Also See for REHVDPTZ12-1:

Table of Contents

3.5 Network Camera Setup

This section describes how to configure the network camera, and is intended for product.

Administrators, who have unrestricted access to all the Setup tools; and Operators, who have

access to the settings for Basic Configuration, Live View, Video & Image, Audio, Event, Dome

Configuration, System

You can configure the network camera by clicking Setup in the top right-hand corner of the Live

View page. Click on this page to access the online help that explains the setup tools.

When accessing the network camera for the first time, the "Admin Password" dialog appears. Enter

your admin name and password, set by the administrator.

NOTE: If the password is lost, the network camera must be reset to the factory default settings.

Please see "Resetting to the Factory Default Settings".

To reset the network camera to the original factory settings, go to the Setup > System >

Maintenance web page (described in "3.5.7 System > Maintenance" of User's Manual) or use the

Reset button on the network camera, as described below:

 Using the Reset button:

Follow the instructions below to reset the network camera to the factory default settings using the

Reset button.

1. Switch off the network camera by disconnecting the power adapter.

2. Press and hold the Reset button (SW1) on the board with your finger while reconnecting the

power.

3. Keep the Reset button (SW1) pressed for about 2 seconds.

4. Release the Reset button (SW1).

5. The network camera resets to factory defaults and restarts after completing the factory reset.

CAUTION: When performing a Factory Reset, you will lose any settings that have been saved.

(Default IP 192.168.30.220)

Table of Contents