Chevrolet Silverado 2014 Infotainment System page 43

Push the power button to turn on
the headphones. A light on the
headphones comes on. If the light
does not come on, check the
batteries. Intermittent sound or static
can also indicate weak batteries.
See Battery Replacement later in
this section.
Turn the headphones off when not
in use.
Move the channel switch on the
headphones to channel 1 or
channel 2.
Channel 1 will provide audio
associated with SCREEN 1 and
channel 2 will provide audio
associated with SCREEN 2 on the
remote control.
The eight infrared red lights on the
overhead screen transmit audio to
the wireless headphone. The
headphones shut off automatically
to save the battery power if the RSE
system is off or if the headphones
are out of range of the transmitters
for more than three minutes. Moving
too far forward or stepping out of the
vehicle can cause the headphones
to lose the signal or have static.
Use the volume control on the
headphones to adjust the volume.
For best audio performance, wear
the headphones as indicated with
L (Left) and R (Right) on the ear
pads. Do not let anything cover the
ear pads.
Caution
Do not store the headphones in
heat or direct sunlight. This could
damage the headphones and
repairs will not be covered by the
warranty. Storage in extreme cold
can weaken the batteries. Keep
the headphones stored in a cool,
dry place.
Infotainment System
If the foam ear pads become worn
or damaged, the pads can be
replaced separately. To purchase
replacement ear pads, call
1-888-293-3332 or contact your
dealer.
Battery Replacement
To change the batteries:
1. Loosen the screw to the battery
door on the left side of the
headphones.
2. Slide the battery door open.
3. Replace the two AAA batteries.
4. Replace the battery door and
tighten the screw.
Remove the batteries if the
headphones will not be used for a
long time.
43