Din Front/Rear Mount; Din Front-Mount - Pioneer deh-2000mp Owner's Manual

Section
(~I_ns_t_a_lI_at_i_o_n ~)
CD
m
::s
cc
-
U )
:::r
1
Rubber bush
Screw Mounting sleeve
Dashboard
• It becomes easy to remove the trim ring if
the front panel is released.
Trim ring
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the dashboard.
Removing the unit
1 Extend top and bottom of the trim ring
outwards to remove the trim ring. (When
reattaching the trim ring, point the side
with a groove downwards and attach it.)
2 Secure the mounting sleeve by using a
screwdriver to bend the metal tabs (90°)
into place.
3 Install the unit.
DIN front/rear mount
This unit can be properly installed either from
"Front" (conventional DIN front-mount) or
"Rear" (DIN rear-mount installation, utilizing
threaded screw holes at the sides of unit chas-
sis). For details, refer to the following installa-
tion methods.
DIN Front-mount
Installation with the rubber bush
1 Insert the mc:>Unting sleeve into the
dashboard.
When installing if") a shallow space, use a sup-
plied mounting sieeve.
If
there is enough
space behind the unit, use factory supplied
mounting sleeve.
Q
Important
• Check all connections and systems before
fi nal installation.
• Do not use unauthorized parts. Use of un-
authorized parts may cause malfunctions.
• Consult your dealer if installation requires dril-
ling of holes or other modifications to the vehi-
cle.
• Do not install this unit where:
- it may interfere with operation of the vehi-
cle.
- it may cause injury to a passenger as a re-
sult of a sudden stop.
• The semiconductor laser will be damaged if it
overheats. Install this unit away from hot
places such as near the heater outlet.
• Optimum performance is obtained when the
unit is installed at an angle of less than 60°.
En
(]I)