Wireless Remote Controller - LG AS-W096E1G0 Engineering Product Data Book

13. Remote controller

Wireless Remote Controller

The controls will look like the following.
5
6
4
2
7
11
8
13
15
Operation Mode Operation Mode
Cooling Operation
Auto Operation or Auto Changeover
Healthy Dehumidification Operation
Heating Operation
• Cooling Model( ), Heat Pump Model(
NOTE
To use the functions printed in blue at the bottom of the buttons press 2
button. Pressing the 2 nd F button activates the blue printed function of the respective button. To cancel the function
press the 2nd F button again else it will automatically cancel if remains idle after 10 seconds.
90 2008 Product Data
1. START/STOP BUTTON
Used to turn off/on the unit.
2. OPERATION MODE SELECTION BUTTON
Signal transmitter
Used to select the operation mode.
3. ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
4. INDOOR FAN SPEED SELECTOR BUTTON
Used to select fan speed in four steps
low, medium, high and CHAOS.
5. JET COOL BUTTON
Used to start or stop the speed cooling.
(It operates fan in super high speed in cooling mode)
6. CHAOS SWING BUTTON
1
Used to stop or start louver movement and set the
desired up/down airflow direction.
3
7. ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping
operation.
10
8. TIME SETTING BUTTONS
Used to adjust the time.
9
12
9. TIMER SET/CANCEL BUTTON
17
Used to set and to cancel the timer operation.
19
10. SLEEP MODE AUTO BUTTON
18
14
11.
16
12. ROOM TEMPERATURE CHECKING BUTTON
Flip-up door
(opened)
13. PLASMA BUTTON(OPTIONAL)
14. HORIZONTAL AIRFLOW DIRECTION CONTROL
15. RESET BUTTON
16. 2nd F BUTTON
17. AUTO CLEAN BUTTON(OPTIONAL)
)
18. HEATER BUTTON(OPTIONAL)
19. LCD LUMINOSITY BUTTON(OPTIONAL)
Used to set sleep mode auto operation.
AIR CIRCULATION BUTTON(OPTIONAL)
Used to circulate the room air without cooling or heating.
ENERGY-SAVING COOLING MODE BUTTON
(OPTIONAL) For inverter type models
Used to check the room temperature.
Used to start or stop the plasma-purification function.
BUTTON (OPTIONAL)
Used to set the desired horizontal airflow direction.
Used prior to resetting time.
Used prior to using modes printed in blue at the
bottom of buttons.
Used to set auto clean mode.
In some models this button has a 2nd function of LED
luminosity control.
(Not available in all models)
Used to adjust LCD luminosity.
nd F button first and then the required function