Pioneer DEX-P9 Service Manual page 67

QQ
3 7 63 1515 0
- How to remove the loading arm assy and spin-
dle motor
1. Remove the E ring of the left fulcrum and remove
the spring and loading arm assy.
2. Remove the connector of the spindle motor and
remove the mounting screws (3).
- How to remove the loading motor assy
1. Remove the gear cover screw and remove the gear
cover.
2. Remove the holder which was tightened together
with the gear cover.
(Note):
At assembly, tighten the holder together with the gear
cover by approaching the holder to the arrow view
direction and touching the tip of the motor shaft.
TE
L 13942296513
At that time, if the holder is tightened with screws while
it is being pressed, the motor load is increased and
causes an error (NG). While the holder is approached,
separate the hand from the holder and the holder is
tightened with the screws.
3. Remove the solder of the motor lead wire.
4. Remove the leaf spring screw and remove the holder
and leaf spring.
5. Put the mechanical unit face downward, remove the
mounting screws of the loading motor assy and remove
the loading motor assy.
www
.
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Loading Arm Assy
Holder
Leaf Spring
Q Q
3 6 7 1 3 1 5
Loading Motor Assy
co
.
DEX-P9,P9R
9 4 2 8
Gear Cover
Holder
0 5 8 2 9 9 4 2 8
Grease Application
(GEM1029)
m
9 9
Spindle
Motor
9 9
67