Sony XR-CA360 Service Manual page 5

QQ
3 7 63 1515 0
3
Supplied with the CD/MD changer
Suministrado con el cambiador de CD/MD
TE
L 13942296513
Precautions
•Choose the installation location carefully so that the unit will not
interfere with normal driving operations.
•Avoid installing the unit in areas subject to dust, dirt, excessive
vibration, or high temperatures, such as in direct sunlight or near
heater ducts.
•Use only the supplied mounting hardware for a safe and secure
installation.
Mounting angle adjustment
Adjust the mounting angle to less than 20°.
Removing the protection collar and the
bracket (4)
Before installing the unit, remove the protection collar 5 and
the bracket 1 from the unit.
1
Remove the protection collar 5.
1 Engage the release keys 7 together with the protection collar
5 .
2 Pull out the release keys 7 to remove the protection collar 5.
2
Remove the bracket 1.
1 Insert both release keys 7 together between the unit and the
bracket until they click.
2 Pull down the bracket 1, then pull up the unit to separate.
Frequency select switch (E model)
The AM (FM) tuning interval is factory-set to the 9 k (50 k) position.
If the frequency allocation system of your country is based on 10 kHz
(200 kHz) interval, set the switch on the bottom of the unit to the 10 k
(200 k) position before making connections.
www
.
http://www.xiaoyu163.com
Source selector
(not supplied )
Selector de fuente
(no suministrado )
XA-C30
BUS AUDIO IN
from car aerial
de antena de automóvil
RCA pin cord (not supplied)
Cable con clavijas RCA (no suministrado)
AMP REM
3
Max. supply current 0.3 A
Corriente máx. de alimentación de 0,3 A
Left
Izquierdo
Right
Derecho
Left
Izquierdo
Right
Derecho
Mounting example (5)
Installation in the dashboard
Notes
• Bend these claws outward for a tight fit, if necessary (5-2).
• Make sure that the 4 catches on the protection collar 5 are properly
engaged in the slots of the unit (5-3).
Mounting the unit in a Japanese car (6)
You may not be able to install this unit in some makes of Japanese
cars. In such a case, consult your Sony dealer.
Note
To prevent malfunction, install only with the supplied screws 4.
How to detach and attach the front panel
(7)
Before installing the unit, detach the front panel.
7-A To detach
Before detaching the front panel, be sure to press (OFF).
Press (RELEASE), then slide the front panel to the left, and pull it off
towards you.
7-B To attach
Attach part A of the front panel to part B of the unit as illustrated
and push the left side into position until it clicks.
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Supplied with XA-C30
Suministrado con el XA-C30
Fuse (10 A)
Fusible (10 A)
CONTROL IN
BUS AUDIO
AUDIO IN OUT
AUDIO
OUT REAR
Blue/white striped
Con raya azul/blanca
Black
White
Negro
Blanco
White/black striped
Con raya blanca/negra
Blue
Grey
Azul
Gris
Grey/black striped
Con raya gris/negra
Red
Green
Rojo
Verde
Green/black striped
Con raya verde/negra
Yellow
Purple
Amarillo
Púrpura
Q Q
3 6 7 1 3 1 5
Purple/black striped
Con raya violeta/negra
co
.
XR-CA360/CA360X
9 4 2 8
Equipment used in illustrations
(not supplied)
Equipo utilizado en las ilustraciones
(no suministrado)
Front speaker
Altavoces delanteros
BUS
Rear speaker
Altavoces traseros
Power amplifier
Amplificador de potencia
CD/MD
Cambiador de CD/MD
6
ANT REM
Max. supply current 0.1 A
Corriente máx. de alimentación de 0,1 A
0 5 8 2 9 9 4 2 8
Warning when installing in a car without ACC
(accessory) position on the ignition key
switch
Be sure to press (OFF) on the unit for two seconds to turn
off the clock display after turning off the engine.
When you press (OFF) only momentarily, the clock display does not
turn off and this causes battery wear.
RESET button
When the installation and connections are completed, be sure to
press the RESET button with a ballpoint pen, etc., after detaching the
front panel.
m
9 9
1
2
4
5
9 9
5