Advertisement
plug (a plug having one blade wider than the other). This plug will fit into the
power outlet only one way. This is a safety feature. If you are unable to insert
the plug fully into the outlet, try reversing the plug. If the plug should still fail to
fit, contact your electrician to replace your outlet. DO NOT alter the safety
features of the polarized plug.
4. Heat setting
Press the
button to cycle through the functions: H, L,
mode and "OFF".
The functions for this button include:
a) Turn the unit on;
b) L MODE: The heating elements operate at 900 W.
c) H MODE: The heating elements operate at 1500 W.
d)
ENERGY SAVING MODE: The heater will automatically select the
appropriate power level to best accommodate your desired temperature. As the
air temperature in the room approaches the set temperature, the heater will
automatically lower the power consumption and provide consistent warmth
without wasting energy.
e) Turn the unit off.
5. Temperature setting (65°F - 85°F)
When the heater is in operation, press the
temperature. There are five distinct settings: 65°F, 70°F, 75°F, 80°F, 85°F
SAFETY FEATURES
Thermal Cut-Off:This heater includes a Thermal Cut-Off Overheat Protection
System that shuts the heater off if it overheats due to abnormal conditions. If this
occurs,turn the heater "OFF",unplug it, and inspect and remove any objects on or
adjacent to the heater.Allow it to cool for a few minutes,plug it back in,and resume
normal operation.
Thermal Fuse: When the unit reaches extremely high temperatures, the heater's
fuse will shut off permanently.Should this occur, bring the heater to a certified
electrician for examination.
TROUBLE SHOOTING
If your heater fails to perate,please follow these instructions:
● Ensure that your circuit breaker or fuse is working properly.
● Be sure the heater is plugged in and that the electrical outlet is working
properly.
● Check for any obstruction.If you find any obstruction,turn the heater "OFF".
Unplug the heater and wait a few minutes for it to cool down.Carefully remove
the obstruction. Plug the heater in and turn it on again by referring to the
OPERATING INSTRUCTIONS.
button to set your desired
3
energy saving heat
Advertisement
