Black & Decker BDCCS20 Instruction Manual page 11

iNSTALLiNG AND REMOVING THE BATTERY
PACK FROM THE TOOL
_, WAR Ni NG:
Make certain the lock-off button is
engaged to prevent switch actuation before
removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery pack into
tool as shown in figure C. Ensure battery pack is fully
seated and fully latched into position.
TO REMOVE BATTERY PACK: Depress the battery
release button as shown in figure D and pull battery
pack out of tool.
SUPPORTING LARGE PANELS / SECURING
WORKPIECE
Support large panels to minimize the risk of blade
pinching and kickback. Large panels tend to sag under
their own weight as shown in figure E.
Supports must be placed under the panel on both
sides, near the line of cut and near the edge of the
panel (figure F).
Never hold piece being cut in your hands or across
your leg (figure G).
Secure the workpiece to a stable platform as shown in
figure H. It is important to support the work properly to
minimize body exposure, blade binding, or loss of control.
Material bends on blade causing
heavy loads or kickback
Support work near cut
11