Sensor Set Up - Oregon Scientific ESM100 User Manual

This product uses Type C current sensor, do not
apply around or remove from HAZARDOUS LIVE
conductors.
Under no circumstances should any force or undue
pressure be applied to any wiring or connections.
Care must be taken at all times to avoid
WARNING
touching or coming into contact with any un-insulated
wires or contacts.
If any difficulty with installation is experienced at all, the
advice of a licensed electrician should be sought.

SENSOR SET UP

It is recommended for current sensor
WARNING
clamp(s) to be installed by a licensed electrician.
Switch off power from the mains before attaching and
detaching sensor(s).
1. Using thumb and finger, press inwards on plastic
tabs located on either side of the sensor clamp to
release top part.
2. Lift the top of the sensor away.
3. Place the main household active or live wire
(outgoing) into the electrical wire hole.
OUTGOING
SUPPLY
NOTE
position so you can close the sensor clamp securely
around the wire.
4. Replace the top of the sensor clamp and push
down to secure.
5. Plug the sensor transmitter cable into any of the
cable sockets.
5
2
1
Do not pull or bend the wires. Ease the wire into