Assembly And Use Of The Nutri Ninja; Pro - Ninja BL470 series Owner's Manual

Assembly and Use of the Nutri Ninja

ASSEMBLY
Fig. 1
CAUTION: DO NOT BLEND HOT FOODS OR HOT
LIQUIDS IN ANY NUTRI NINJA
IMPORTANT: Place the motor base on a clean,
dry, level surface such as a counter or table top.
1 Make sure that the motor base is plugged in for use. No
lights will turn on.
2
Add ingredients to the cup.
NOTE: Do not overfill! to avoid spilling, do not add
ingredients past the "MAX" fill line.
3
Place the blade assembly onto the cup and twist it on
tightly until you have a good seal. (Fig. 1)
4 Turn the cup upside down and place it onto the motor
base, aligning the tabs on the cup with the motor base.
Turn it clockwise, until you feel it click into place. The
lights will illuminate. (Fig. 2)
5 Press one of the buttons to activate. (Fig. 3)
Fig. 2
CUP.
®

Pro

®
USE
Fig. 3
6
To remove the cup, ensure that the motor has stopped
running. Then turn the cup anticlockwise (Fig. 4) and
pull straight up to remove. (Fig. 5)
7
Turn the cup upright and remove the blade assembly
by twisting the blade assembly anticlockwise. Be sure
to store the blade assembly attached to an empty cup
when not in use.
8
Twist the Sip & Seal
drink on the go. Press flip top cap firmly into the
opening to get the best seal. The flip top cap locks open
when pressed backward.
START
STOP
9
Make sure that the motor base is unplugged when not
in use.
10 To remove the motor base unit, tip the unit forward
from the rear to easily disengage the suction cups.
www.sharkninjamanuals.com
REMOVAL
Fig. 4
lid onto the cup to enjoy your
®
9 0 0 W A T T S
PULSE
Fig. 5
8