Roland XC-540 Setup Manual page 48

7. Installing the Blade
3.
Install the blade holder.

Loosen the screw shown in the figure.
v
Support the screw from below and insert the blade holder.
If installed without supporting the screw in this way, cutting quality may become poor.
Insert until the collar is
flush with the surface.
w Tighten the screw.
Tug the blade holder upward to make sure it does not come loose.
x
FINISHED?
Important Note on the Handling and Use of the Cutting Carriage
Leave the cutting-carriage screw loose when no blade holder is installed. Keeping the screw tightened causes
the blade-holder insertion hole to become gradually smaller, making installation difficult.
46
Screw
Screw
Support it from below.
Screw
Close the front cover, then press .