Assembly And Use For The Bowl - Ninja BL820UK Owner's Manual

Assembly and Use for the Bowl

WARNING: Never leave the appliance unattended while in use.
ASSEMBLY
Fig. 14
Fig. 15
IMPORTANT: Make sure that the motor base is
plugged in for use.
1 Place the motor base on a clean, dry, level surface
such as a counter or table top.
2 Align and lower the Bowl onto the motor base.
(Fig. 14) Handle should be aligned slightly to the
right of the "LOCK" symbol on the motor base.
3 Rotate the bowl clockwise as far as it will go to
lock in place. (Fig. 15)
4 The bowl can be placed on the motor base two
ways; the handle can be on the front right corner or
the front left corner. (Fig. 16a, Fig. 16b)
5 Holding the desired blade by the top of the shaft,
place it onto the drive gear inside the bowl. Ensure
that the attachment is seated properly and is
standing upright. (Fig. 17)
NOTE: The blade will fit loosely on the star-shaped
post.
6 Add the ingredients to the bowl, making sure that
they do not exceed the highest measured marking
line on the side of the bowl.
11
Fig. 16a
Fig. 16b
7 Holding the lid from the feed chute, place it on top
of the bowl and turn clockwise aligning the arrow
( ) located on the lid with the arrow ( ) located
on the bowl's handle. (Fig. 18)
8 Plug the power cord into the electrical outlet and
press up on the power toggle ( ) to turn the power
"On".
NOTE: The bowl is not intended for blending
drinks. Do not exceed the "Max Fill" mark on
the bowl.
NOTE: To add liquids during
processing, remove the food
pusher from the feed chute to
drizzle in liquids. Do not remove
the lid while in use.
TIP: Turn the unit down to the
lowest setting before adding
additional liquids.
Fig. 17
Fig. 18