Indoor Unit - Panasonic CS-ME5RKUA Service Manual

9.2

Indoor Unit

9.2.1 How to Fix Installation Plate
The mounting wall shall be strong and solid enough to prevent it from the vibration.
Measuring
Tape
ME7***
The center of installation plate should be at more than  at right and left of the wall.
The distance from installation plate edge to ceiling should more than .
From installation plate center to unit's left side is .
From installation plate center to unit's right side is .
○
B : For left side piping, piping connection for liquid should be about  from this line.
: For left side piping, piping connection for gas should be about  from this line.
1 Mount the installation plate on the wall with 5 screws or more (at least 5 screws).
(If mounting the unit on the concrete wall, consider using anchor bolts.)
Always mount the installation plate horizontally by aligning the marking-off line with the thread and using
o
a level gauge.
2 Drill the piping plate hole with ø2 3/4" (ø70 mm) hole-core drill.
Line according to the left and right side of the installation plate. The meeting point of the extended line is
o
the center of the hole. Another method is by putting measuring tape at position as shown in the diagram
above. The hole center is obtained by measuring the distance namely 5 1/16" (128 mm) for left and right
hole respectively.
Drill the piping hole at either the right or the left and the hole should be slightly slanting to the outdoor
o
side.
9.2.2 To Drill a Hole in the Wall and
Install a Sleeve of Piping
1 Insert the piping sleeve to the hole.
2 Fix the bushing to the sleeve.
3 Cut the sleeve until it extrudes about 19/32"
(15 mm) from the wall.
CAUTION
When the wall is hollow, please be sure
to use the sleeve for tube assembly to
prevent dangers caused by mice biting
the connection cable.
4 Finish by sealing the sleeve with putty or
caulking compound at the final stage.
Wall
More than 1
2
17
9 / "
32
(241.5 mm)
PIPEHOLECENTER
D IS TA N C E
T O P IP E
H O L E
5 1 / "
C E N T E R
16
1 2 8 m m
(128 mm)
Model
or
Wall
More
screw
than 2
1
5 / "
16
(128 mm)
1
Installation plate
For best strength of
INDOOR unit installation,
it is highly recommended
to locate " " at 5 position
as shown.
Dimension
1 2 3
9 7 9
19 / " 3 / " 17 /
32 32 32
(490 mm) (82 mm) (439 mm)
ø2
through hole
17
More than 1
DISTANCE TO
PIPE HOLE
CENTER 128 mm
17
9 / "
32
(241.5 mm)
PIPE HOLE
CENTER
5 1 / "
16
(128 mm)
4 5
11
" 17" 1 / " 3
16
(432 mm) (43 mm) (95 mm)
Wall
Indoor Outdoor
19
/
32
Sleeve for
tube
assembly
3
/ " (ø70 mm)
4
Putty or caulking compound
Wall
6
3
/ "
4
" (15 mm)
Approx. 7 /32" - 9 /32"
(5-7 mm)
Bushing for tube
assembly