Advertisement
To change the type of indication at your phone:
• Do not lift the receiver.
• Press the FEAT button.
• Press the desired [CALL COVERAGE] button.
The present indication mode will be displayed.
• Dial the number for the desired mode.
• Dial
for immediate display and ringing.
or
• Dial
for delayed indication (display and ringing
starts
if
call
is
not
preprogrammed time).
or
• Dial
for no ringing (lamp indication only).
Call Divert
When a call is ringing at your station and your
station is idle, off hook, or on a call, you can send
that call immediately to your Call Forward No
Answer Destination.
• Press your [MBOX] key.
Call Pick-Up
Internal Group
You may answer calls to any extension in your pick-
up group without dialing the extension number.
When you hear a call ringing at another extension:
• Lift receiver.
• Press FEAT and dial
+ .
or
• Press the [GROUP CALL PICK-UP] button (if
assigned).
The incoming call is connected to your extension.
Direct Extension
You may also answer an incoming call at another
extension.
• Lift the receiver.
• Press the FEAT button and dial
or
• Press the [DIRECT CALL PICK-UP] button.
• Dial the number of the extension where the call is
ringing.
The incoming call is connected to your extension.
Call Recording
You can record a call to voice mail by following the
procedures listed below:
Important: Use of this feature may be prohibited by
state law.
To start recording a call to voice mail
While on an ICM, outside line or conference call:
• Press the [RECORD] button.
• Your call will begin recording to voice mail.
Note: A four-party conference call cannot be
recorded.
15
answered
within
a
+ .
Cancel Follow Me (From the forwarded station)
• Lift the receiver (handset).
• Press Scroll > Fwd—only once.
• The 12i/d will first display the current forward
status for two seconds.
• Press Cancel.
• Press the Speaker button to end the operation.
Forward—Quick Set
The Forward—Quick Set feature allows you to turn
on/off the current forward destination programmed
on your 12i/d telephone.
Forward Quick Set Active/Inactive
Follow the Set Forward Destination procedure on
the previous page to enable the Quick Set menu.
The Quick Set menu will not be active if the
Forward Cancel feature has been used or if the
station has not been forwarded.
Use the Quick Set menu to activate and deactivate
your station's forward status.
Once the station has been forwarded, follow the
steps below to set the forward status to inactive or
active:
• Press Scroll > Fwd.
• Press Scroll > Q-Set.
• Lift the receiver to return to the main menu.
• When the asterisk* appears, forward is active
• When the asterisk* disappears, forward is
inactive.
Park
Park a call so that it can be answered from another
extension.
Putting a call in Call Park
When speaking on an outside line:
• Select the Park menu key.
• You will hear confirmation tone and an asterisk*
will appear next to the Park menu key.
• Hang up the phone.
If the call is not picked up, the call will return to
your phone.
Picking up a call that is Parked
From the extension that parked the call:
• Lift receiver or press the Speaker key.
• Press the Park* menu key.
From another extension:
• Lift receiver or press the Speaker key.
• Press the Park menu key.
• Dial the extension number where the call is
parked to pick-up the call.
8
Advertisement
