Pioneer AVX-7300 Installation Manual page 4

1. Yellow (video input) 15 cm
(VIDEO INPUT)
2. Orange/white
6. Fuse resistor
To lighting switch terminal.
3. Red
6. Fuse resistor
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
4. Yellow
7. Fuse holder
To terminal always supplied with power
regardless of ignition switch position.
5. Black (ground)
To vehicle (metal) body.
9. Connection method
10. Clamp the parking
brake switch power
8. This Product
supply side lead.
11. Clamp firmly with
needle-nosed pliers.
12.
Note:
• The position of the parking brake switch
depends on the vehicle model. For details,
consult the vehicle Owner's Manual or dealer.
13. Light green
Used to detect the ON/OFF status of the parking
brake. This lead must be connected to the power
supply side of the parking brake switch.
14. Power supply side 16. Parking brake
switch
15. Ground side
1. AV cable
(supplied with the Multi- 2. Multi-Channel AV
Channel AV Master Unit) Master Unit (e.g. AVM-P9000)
(sold separately)
3. Gray
4. Green
5. Yellow
(DVD
7. Blue
6. Red
VIDEO IN)
3. Gray
8. Optical cable
(supplied with the Multi-Channel
AV Master Unit)
4. Green
9. IP-BUS cable
(supplied with the Multi-Channel
AV Master Unit)
Fig. 8
∏ qJAë
12. Normally, connection is not necessary.
If the DVD player (e.g. SDV-P7) is installed in
a location that prevents reception of the remote
control signal, connect with a separately sold
AV-BUS extension cable. (Or connect a separately
sold remote sensor to the DVD player.)
7. Blue
13. This product
14. Black
IP-BUS STAND ALONE
15. DVD player
11. Yellow
(front video output)
10. RCA cable
(supplied with the DVD pla ayer)
7. Blue
17. 20 pin cable
3 m
(supplied)
40 cm
6. Red
(e.g. SDV-P7)
(sold separately)
16. Not used.
6. Red
Fig. 9
π qJAë