Pioneer AVX-7300 Operation Manual
Pioneer AVX-7300 Operation Manual

Pioneer AVX-7300 Operation Manual

7 inch wide av system display
Hide thumbs Also See for AVX-7300:

Advertisement

7 Inch Wide AV System Display
ENGLISH

Operation Manual

AVX-7300

Advertisement

Table of Contents
loading

Summary of Contents for Pioneer AVX-7300

  • Page 1: Operation Manual

    7 Inch Wide AV System Display ENGLISH Operation Manual AVX-7300...
  • Page 2 Selecting fine audio equipment such as the unit you’ve just purchased is only the start of your musical enjoyment. Now it’s time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association’s Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level.
  • Page 3: For U.s. And Canadian Models

    Precaution After-sales Service for Pioneer Products Please contact the dealer or distributor from where you purchased the product for its after-sales service (including warranty conditions) or any other information. In case the...
  • Page 4: Important Safeguards

    IMPORTANT SAFEGUARDS PLEASE READ ALL OF THESE INSTRUCTIONS REGARDING YOUR DISPLAY AND RETAIN THEM FOR FUTURE REFERENCE 1. Read this manual fully and carefully before operating your display. 2. Keep this manual handy for future reference. 3. Pay close attention to all warnings in this manual and follow the instructions carefully.
  • Page 6: Table Of Contents

    Contents Dear Customer ... i For U.S. and Canadian Models ... ii About This Product Important Precaution IMPORTANT SAFEGUARDS ... iii PLEASE READ ALL OF THESE INSTRUCTIONS REGARDING YOUR DISPLAY AND RETAIN THEM FOR FUTURE REFERENCE Before Using ... 2 Before Using This Product ...
  • Page 7: Before Using

    Before Using This Product About This Product [For European models] • This product complies with the EMC Directives (89/336/EEC, 92/31/EEC) and CE Marking Directive (93/68/EEC). Video System of a Connected Component [For models except U.S. and Canadian models] This product is NTSC/PAL system compatible. When connecting other components to this product, be sure components are compatible with the same video systems.
  • Page 8: To Ensure Safe Driving

    To Ensure Safe Driving WARNING • To avoid the risk of accident and the potential violation of applicable laws, this product is not for use with a video screen that is visible to the driver. • In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal.
  • Page 9: In Case Of Trouble

    In Case of Trouble Should this product fail to operate properly, contact your dealer or nearest authorized Pioneer Service Station. Preventing the Battery from Becoming Exhausted When using this product, be sure your car engine is running. If you use this product when your engine is not running, the battery will become exhausted.
  • Page 10: Detaching And Replacing The Front Panel

    Detaching and Replacing the Front Panel Theft Protection The front panel of this product is detachable to discourage theft. When the front panel is detached, this product will not be operable as the front panel contains the Signal receptor and OPEN/CLOSE button that are necessary for opera- tion.
  • Page 11: Key Finder

    Key Finder The following diagram shows the display when it is deployed. OPEN/CLOSE button Display RESET button ANGLE buttons RGB button V.SOURCE button WIDE button...
  • Page 12: Operation Of The Display

    Operation of the Display Deploying the Display • Turn your vehicle’s engine ON. The display will be automatically deployed by the automatic close/open mode. If the display is not automatically deployed, press the OPEN/CLOSE button. Note: • The automatic close/open mode will operate the display as follows. * When the ignition switch is turned OFF while the display is deployed, the display will be closed after approximately 6 seconds.
  • Page 13: Screen Angle Adjustment

    Screen Angle Adjustment The angle of this product’s screen continues changing as long as you keep pressing the ANGLE button. • Adjust the screen to an easily viewable angle. Precaution: • If you can hear the display knocking against your vehicle’s console or dashboard, press the ANGLE button on the (–) side to move the screen a little forward.
  • Page 14: Closing The Display

    Closing the Display • Turn the vehicle’s engine OFF. The display will be automatically closed by the automatic close/open mode. If the display does not close automatically, press the OPEN/CLOSE button. Note: • When closing the display, check to make sure that it has closed completely. If the display has stopped halfway, leaving it like this could result in damage to it.
  • Page 15: Changing The Wide Mode

    Changing the Wide Mode You can select a desired mode for enlarging a 4:3 picture to a 16:9 one. • Select the desired mode in the following order: Full (FULL) = Just (JUST) = Cinema (CINEMA) = Zoom (ZOOM) = Normal (NORMAL) Full (FULL) A 4:3 picture is enlarged in the horizontal direction only, enabling you to enjoy a 4:3...
  • Page 16: Switching The Illumination

    Switching the Illumination Color (For European models) This product is equipped with two illumination colors, green and red. You can select the desired illumination color. • Switch to the desired illumination color. Hold for 2 seconds Repeat the preceding operation to switch to the previous color.
  • Page 17: Switching The Video Source

    Switching the Video Source 7 Switching to RGB You can watch videos from a component connected to this produt’s RGB input. • Switch to RGB. Repeat the preceding operation to switch to the previous video source. Note: • If you select the “AVM” video select setting in the display setting menu, video is locked to RGB.
  • Page 18: Setting The Display

    Operating the Setting Menu Entering the Display Setting Menu Perform display and picture setting with this menu. Enter the Display Setting Menu. Select the desired mode in the following order: VSEL SET = AUTO OPEN = BRIGHT = COLOR* = HUE* = DIMMER To cancel the Display Setting Menu, press the WIDE button again for 2 seconds.
  • Page 19: Switching The Video Select Setting

    Switching the Video Select Setting You can change the video select setting. Press the WIDE button and select the video select mode (VSEL SET) in the Display Setting Menu. Switch to the desired video select setting in the following order: AUTO = MANUAL = AVM 7 AUTO When the Head Unit source is switched to a component (e.g.
  • Page 20: Adjusting The Bright

    Adjusting the Bright You can adjust the bright of the picture. Press the WIDE button and select the Bright mode (BRIGHT) in the Display Setting Menu. Adjust the Bright. Note: • The density of the display black can be adjusted within the range of “–24” to “+24.” •...
  • Page 21: Adjusting The Hue

    Adjusting the Hue You can adjust the hue of the picture. Press the WIDE button and select the Hue mode (HUE) in the Display Setting Menu. Adjust the Hue. Note: • The display changes within a range from “–24” to “+24” as the distinction of the picture changes from reddish to greenish.
  • Page 22: Others

    • If moisture or foreign matter should get inside the product, turn OFF the power immediately and consult your dealer or the nearest autho- rized PIONEER Service Station. Using the product in this condition may result in a fire or electric shock, or other failure.
  • Page 23: About The Liquid Crystal (Lcd) Screen

    * When the fluorescent tube reaches the end of its useful life, the screen will be dark and the image will no longer be projected. If this happens, consult your dealer or the nearest authorized PIONEER Service Station.
  • Page 24: Appendix

    Specifications General Power source ... 14.4 V DC (10.8 – 15.1 V allowable) Grounding system ... Negative type Max. current consumption ... 4 A Dimensions (DIN) (chassis) ... 180 (W) × 50 (H) × 160 (D) mm [7-1/8 (W) × 2 (H) × 6-1/4 (D) in] (nose) ...
  • Page 28 TEL: (03) 9586-6300 PIONEER ELECTRONICS OF CANADA, INC. 300 Allstate Parkway, Markham, Ontario L3R OP2, Canada TEL: (905) 479-4411 PIONEER ELECTRONICS DE MEXICO, S.A. de C.V. San Lorenzo 1009 3er. Piso Desp. 302 Col. Del Valle Mexico, D.F. C.P. 03100 TEL: 5-688-52-90 <KNKFF/01D00000>...

Table of Contents