Installing the Heatsink Assembly
1.
Place the heatsink assembly in the slot by aligning with the screw holes.
2.
Tighten the screws to secure the heatsink assembly to the system board.
3.
Connect the heatsink-assembly cable to the system board.
4.
Install:
a.
optical drive
b.
hard-drive assembly
c.
front bezel
d.
cover
5.
Follow the procedures in
Removing the WLAN Card
1.
Follow the procedures in
2.
Remove:
a.
cover
b.
front bezel
3.
Follow the steps to remove the WLAN card:
a. Slide the WLAN antenna cable cover from the cables [1].
b. Remove the screw that secures the WLAN card to the system board.
c. Disconnect the antenna cables from the WLAN card.
d. Pull the WLAN card from the connector on the system board.
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
15