Table of Contents
Advertisement
1. Coil support plate
1. Slot
2. Feeder body
1
1. Air fitting
2. Air socket
•
Lift and turn the coil support plate to set it to the correct step. When
005242
loading 57 or 65 mm long nails, use the bottom step. When loading 45 or
50 mm long nails, use the middle step. When loading 32 or 38 mm long
nails, use the top step. If the tool is operated with the coil support plate
set to the wrong step, poor nail feed or malfunction of the tool may result.
1
•
Place the nail coil over the coil support plate. Uncoil enough nails to
005243
reach the feed claw. Place the first nail in the driver channel and the
1
second nail in the feed claw. The nail heads must be in the slot in the
feeder body. Place other uncoiled nails on feeder body. Close the
magazine cap and door after checking to see that the nail coil is set
properly in the magazine.
2
Connecting air hose
•
Lock the trigger. Slip the air socket of the air hose onto the air fitting on
005244
the nailer. Be sure that the air socket locks firmly into position when
installed onto the air fitting. A hose coupling must be installed on or near
2
the tool in such a way that the pressure reservoir will discharge at the
time the air supply coupling is disconnected.
7
Advertisement
Table of Contents
