Dell Precision 620 User Manual page 88

1. Turn off the system, including any attached peripherals, and disconnect all the AC power cables from their electrical outlets. Also, disconnect
any telephone or telecommunication cables from the computer.
CAUTION: Before you remove the computer cover, see
2. Remove the computer cover.
3. Check all the expansion-card connections in the computer.
4. Check the diskette/tape drive, hard-disk drive, and all other internal connections to make sure that all cables are properly connected and that
all components are properly seated in their connectors and sockets.
5. Replace the computer cover, reconnect the system to an electrical outlet, and reconnect any telephone or telecommunication cables.
6. Insert the Dell Precision ResourceCD into the CD-ROM drive, and reboot the system.
7. Run the System Board Devices test group in the
If the tests complete successfully, your system is operating properly. If any of the tests fail, see
obtaining technical assistance.
Troubleshooting the Battery
CAUTION: A new battery might explode if you install it incorrectly. Replace the battery only with the same or equivalent type
recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.
NOTE: Before disconnecting a peripheral from the system or removing a component from the system board, verify that the standby
power LED on the system board has turned off. For the location of this LED, see
If an error message indicates a problem with the battery or if
off, the battery may be defective.
To troubleshoot the battery, perform the following steps:
1. Turn off the system, including any attached peripherals, and disconnect all the AC power cables from their electrical outlets. Also, disconnect
any telephone or telecommunication cables from the computer.
CAUTION: Before you remove the computer cover, see
2. Remove the computer cover.
3. Reseat the battery in its socket.
The battery is a coin cell that snaps into a socket on the system board.
4. Replace the computer cover
5. If the problem is not resolved, replace the battery.
Your Dell system uses a 3-V CR2032 coin cell battery.
If the problem is still not resolved, you may have a faulty system board. See
Troubleshooting Expansion Cards
NOTE: Before disconnecting a peripheral from the system or removing a component from the system board, verify that the standby
power LED on the system board has turned off. For the location of this LED, see
If an error message indicates an expansion-card problem or if an expansion card seems to perform incorrectly or not at all, the problem could be a
faulty connection, a conflict with software or other hardware, or a faulty expansion card. To troubleshoot expansion cards, perform the following
steps:
1. Turn off the system, including any attached peripherals, and disconnect all the AC power cables from their electrical outlets. Also, disconnect
any telephone or telecommunication cables from the computer.
CAUTION: Before you remove the computer cover, see
2. Remove the computer cover.
Dell Diagnostics.
System Setup
and restart the system.
"Safety First—For Your and Your
Figure 1 in "Installing System Board Options."
loses the system configuration information when the computer is turned
"Safety First—For You and Your
"Getting Help" for instructions on obtaining technical assistance.
Figure 1 in "Installing System Board Options."
"Safety First—For You and Your
Computer."
"Getting Help" for instructions on
Computer."
Computer."