Dell Precision 620 User Manual page 100

failure
Diskette subsystem
reset failed
Drive not ready
Diskette write
protected
Gate A20 failure
General failure
Hard disk
configuration error
Hard disk controller
failure
Hard disk failure
Hard-disk drive read
failure
Invalid
configuration
information - please
run SETUP program
Keyboard clock line
failure
Keyboard controller
failure
Keyboard data line
failure
Keyboard failure
Keyboard stuck key
failure
Memory address line
failure at address,
read value expecting
value
Memory allocation
error
Memory data line
failure at address,
read value expecting
value
Memory double word
logic failure at
address, read value
expecting value
Memory odd/even
logic failure at
address, read value
expecting value
Memory write/read
failure at address,
read value expecting
value
Memory size in CMOS
invalid
Memory tests
The diskette drive controller may be faulty.
No diskette is in the drive. The operation requires a
diskette in the drive before it can continue.
The diskette write-protect feature is activated.
One or more RIMMs may be loose.
The operating system is unable to carry out the
command.
The hard-disk drive failed initialization.
The hard-disk drive failed initialization.
The system configuration information does not match
the hardware configuration.
A cable or connector may be loose, or the keyboard or
keyboard/mouse controller may be faulty.
One or more RIMMs may be faulty or improperly
seated.
The software you are attempting to run is conflicting
with the operating system or another application
program or utility.
One or more RIMMs may be faulty or improperly
seated.
The amount of memory recorded in the system
configuration information does not match the memory
installed in the computer.
The memory test did not complete.
Run the Diskette tests in the Dell
Put a diskette in the drive or close the drive latch.
Remove the diskette from drive A and move the write-
protect tab to the unlocked position.
See "Troubleshooting System Memory."
This message is usually followed by specific
information—for example, PRINTER OUT OF
PAPER. Respond by taking the
appropriate action.
See "Troubleshooting Drives."
See "Troubleshooting Drives."
Enter System Setup and correct the system
configuration information.
See "Troubleshooting the Keyboard."
See "Troubleshooting System Memory."
Turn off the computer, wait 30 seconds,and then turn it
on. Try to run the program again. If the problem
persists, contact the software company.
See "Troubleshooting System Memory."
Reboot the computer. If the error appears again, see
"Getting Help" for instructions on obtaining technical
assistance.
Rerun the memory test.
Diagnostics.