Advertisement
Quick Links
Quick-Start Guide
Product specifications are subject to change without notice.
Due to ongoing development, the actual product may vary from
images shown.
This product contains chemicals known to the State of California
to cause cancer, birth defects and other reproductive harm.
This product is not a toy! (14+) Recommended for ages 14 and
up. Adult supervision required for ages under 18 years old.
Contains small parts, keep out of reach of children 3 years of
age and younger.
Distributed in the US by:
Firelands Customer Service/Product Support
1133 Libra Drive, Lincoln, NE 68512
www.firelandsgroup.com
1-800-205-6773
customerservice@firelandsgroup.com
Full manual available to download from: www.Ares-RC.com
Part Number:
AZSZ2802
AZSZ2802A Crossfire Racer Quad RFR: 25mW VTX
Distributed in the
UK by:
J Perkins Distribution Ltd,
Lenham,
Kent, UK
ME17 2DL.
www.jperkins.com
Crossfire Racer Quad RFR: 200mW VTX
To download the full Owner's Manual &
Technical Information Guide, please visit
www.Ares-RC.com or scan the QR code with
your smart phone.
Distributed in Australia by:
Model Engines (Aust.) Pty. Ltd.,
Unit 1, 158-168 Browns Road,
Noble Park,
Victoria,
3174,
Australia.
www.modelengines.com.au
Ph (03) 8793 5555
warranties@modelengines.com.au
MADE IN CHINA
Advertisement
Summary of Contents for Ares RC Crossfire AZSZ2802
- Page 1 Quick-Start Guide Product specifications are subject to change without notice. Due to ongoing development, the actual product may vary from images shown. Part Number: AZSZ2802 Crossfire Racer Quad RFR: 200mW VTX This product contains chemicals known to the State of California AZSZ2802A Crossfire Racer Quad RFR: 25mW VTX to cause cancer, birth defects and other reproductive harm.
- Page 2 QUICK-START GUIDE This Quick Start guide is written for the RFR (Ready for Receiver) version of the Crossfire. A full instruction manual is available to download from www.ares-rc.com Remove the components from the box and ensure you have the following parts: •...
- Page 3 Plug the wires into the respective sockets on your receiver noting that the single-pin connectors should be attached to the ‘signal’ pin, usually reserved for the yellow, orange or white wire. Secure your receiver to the upper frame using hook and loop tape and secure the aerial(s).
- Page 4 BINDING/PAIRING GUIDE QUICK-START GUIDE Before flying your Crossfire you’ll need to configure and tune the on-board flight controller using Cleanflight open-source software. This software can be sourced via Google Chrome using the following method: 1. Open Google Chrome 2. Enter ‘Apps’ (icon in top left corner) 3.
- Page 5 With the propellers still removed, switch your transmitter ON and connect the Crossfire’s battery. A series of beeps will be heard confirming that the quad is ready to arm. Place the Crossfire on a level surface and arm the motors by moving the throttle stick to the bottom right corner of the gimbal (the default position for Mode 2 transmitters) and holding for three seconds.
- Page 6 QUICK-START GUIDE Remove the downlink antenna, fit the fuselage shell, then refit the downlink antenna. Your Crossfire is now ready to fly. Please note that specific guidelines exist regarding the lawful flying of ‘Small Unmanned Aircraft’ and ‘Small Unmanned Surveillance Aircraft’ such as the camera-equipped Crossfire.
Need help?
Do you have a question about the Crossfire AZSZ2802 and is the answer not in the manual?
Questions and answers