Troubleshooting - Makita BHX2500 Instruction Manual

Hide thumbs Also See for BHX2500:
Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1

TROUBLESHOOTING

Before  making  a  request  for  repairs,  check  a  trouble  for  yourself.  If  any  abnormality  is  found,  control  your  machine  according  to  the  description  of  this  
manual.  Never  tamper  or  dismount  any  part  contrary  to  the  description.  For  repairs,  contact   A uthorized  Service   A gent  or  local  dealership.
State of abnormality
Engine  does  not  start
Engine  stops  soon
Engine  speed  does  not  increase
Engine  does  not  stop.
Run  engine  at  idling,  and  set  choke  lever  to  
CLOSE.
When  the  engine  does  not  start  after  warm-­up  operation:
If  there  is  no  abnormality  found  for  the  check  items,  open  the  throttle  by  about  1/3  and  start  the  engine.
Probable  cause  (malfunction)
Failure to operate primer pump
Low  pulling  speed  of  starter  rope
Lack  of  fuel
Clogged  fuel  filter
Broken fuel tube
Deteriorated  fuel
Excessive  suction  of  fuel
Detached  plug  cap
Contaminated spark plug
Abnormal  clearance  of  spark  plug
Other  abnormality  of  spark  plug
Abnormal  carburetor
Starter rope cannot be pulled
Abnormal  drive  system
Insufficient  warm-­up
Choke  lever  is  set  to  "CLOSE"  although  engine  
is warmed up
Clogged  fuel  filter
Contaminated or clogged air cleaner
Abnormal  carburetor
Abnormal  drive  system
Detached  throttle  wire
Abnormal  drive  system
Detached  connector
Abnormal  electric  system
18
Remedy
Push  7  to  10  times.
Pull  strongly.
Feed  fuel.
Clean
Straighten fuel tube
Deteriorated  fuel  makes  starting  more  difficult.
Replace  with  new  one.  (Recommended  re-
placement:  1  month)
Set throttle lever from medium speed to high
speed,  and  pull  starter  handle  until  engine  
starts.
If  engine  will  not  start  still,  remove  spark  plug,  
make  electrode  dry,  and  reassemble  them  as  
they  originally  are.  Then,  start  as  specified.
Attach  securely
Clean
Adjust  clearance
Replace
Make  request  for  inspection  and  maintenance.
Make  request  for  inspection  and  maintenance
Make  request  for  inspection  and  maintenance
Perform warm-up operation
Set  to  "OPEN"
Clean
Clean
Make  request  for  inspection  and  maintenance
Make  request  for  inspection  and  maintenance
Attach  securely
Make  request  for  inspection  and  maintenance
Attach  securely
Make  request  for  inspection  and  maintenance.

Advertisement

Table of Contents
loading

Table of Contents