Bobbin Winding; Inserting A Bobbin - Pfaff GrandQuilter Owner's Manual

Operating your GrandQuilter
A
C

Bobbin winding

1. Pull the thread stand up as far as it will go
and turn it around until it clicks into position.
2. Pass the thread through the guide (A) on
the thread stand from behind.
3. Pass the thread through the second thread
guide (B).
4. Pass the thread under the bobbin winding
tension disk (C).
5. Thread through the hole (D) in the bobbin
from the inside to the outside. Place the
bobbin on the bobbin winder spindle by
matching the hole on the bobbin with the
spring on the bobbin winder spindle (E).
6. Push the bobbin winder stop to the left
(F).
7. Hold the end of the thread and press the
bobbin winding button. Press the bobbin
winding button again to stop the bobbin
when it has made several turns, and cut the
thread close to the hole in the bobbin.
8. Press the bobbin winding button again. The
machine will stop automatically when the
bobbin is full and the bobbin winder stop will
return to the original position.
18
B
D
E
F
9. Cut the thread with scissors. Remove the
bobbin from the bobbin winder spindle.
Note: This machine has an exclusive motor for bobbin
winding, which allows you to wind a bobbin while
sewing.

Inserting a bobbin

1. Place a bobbin in the bobbin case making
sure the thread winds clockwise.
2. Draw the thread through the slit (A) of the
A
bobbin case.
3. Continue to draw the thread under the
tension spring and through the opening (B).
B 4. Pull about 4" (10cm) of thread.
Operating your GrandQuilter
19