Component Testing Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Component
1.
2.
Overload
1.
2.
PTC Starter
18
Test Procedure
Remove overload from circuit and
allow 2 min. to cool.
Check resistance between overload
terminals .......................................... If terminals read open or dead short, replace
Remove overload from circuit and
allow 2 min. to cool.
Check resistance between overload
terminals
overload.
If terminals read open or dead short, replace
overload.
SMR-0003
Service Action
© Viking Range Corporation