GMC 2010 T-Series Owner's Manual page 118

Finding a Station
FM/AM : Press to switch between FM1, FM2, or AM.
The selection displays.
y z
(Tune): Press either arrow to go to a higher or to
a lower frequency.
Press either arrow for less than a second and the
station frequency changes by one.
Press either arrow for one second or more to seek
stations with a strong signal that are in the selected
band in ascending order.
SCAN : Press to scan radio stations in the direction
of increasing frequencies. The radio goes to a station,
plays for a few seconds, then goes to the next station.
The radio display flashes each radio station being
scanned. Press again to stop scanning, and the last
scanned station plays.
3-42
Setting Preset Stations
Up to 18 stations (six FM1, six FM2, and six AM),
can be programed on the six numbered pushbuttons,
by performing the following steps:
1. Press FM/AM to select FM1, FM2, or AM.
2. Tune in the desired station by pressing
y z
the arrows.
3. Press and hold one of the six numbered
pushbuttons. When that numbered pushbutton
is pressed, the station that was set, returns for
that pushbutton.
4. Repeat the steps for each pushbutton.
The stored preset stations are deleted if power to the
radio is lost, or if the battery is disconnected.
Setting the Tone (Bass/Treble)
AUDIO : Press and release until BASS (BA:0) or
TREBLE (TR:0) displays. The display shows the bass
or treble level. Each time the AUDIO button is pressed,
the audio mode indicator changes. Once the desired
tone displays, press either
decrease the setting.
If a station is weak or has static, decrease the treble.
If AUDIO is not pressed, after 10 seconds audio mode
times out and returns to NORMAL MODE.
y z
arrow to increase or