Service Procedures; Service Procedures For Gigaset 4000 Micro; Service Procedures For Gigaset 4010/ 15 Micro Base Station - Siemens Gigaset 4010 Micro Service Manual

3 Service procedures

3.1

Service procedures for Gigaset 4000 micro

Note: The service procedures are confidential.
Reset, Displaytest, Software-Version & IPUI, Speechpath test and Metering mode:
switch on and keep pressed until display testpattern is visible, then release all
SW-Version, IPUI
Read out software version
and the IPUI number
Press 4685463
Same as entering: "HOTLINE"
This code generates a fundamental
reset on the handset. All settings are
reset to factory defaults (Tel.book,
network provider list and list of
incoming/ missed calls). Handset is
still registered to base.
The items QS-Data,Batt mode and DSP parameters have been implemented for
development and production purposes and are not needed in service.

3.2 Service procedures for Gigaset 4010/ 15 Micro base station

Note: For parameters X, Y, option see table below.
Press: "menu-key", 8, 9, X, 76200 (only if X=3 or 4), Y, select option, o.k.
A pos. acknowledge (rising sequence of notes) indicates that the procedure has
been accepted.
press 1, 4 and 7 simultaneously
and keep pressed
keys
press 76200
Speechpath test
Switch a direct loop from
microphone to earphone
(check the path by blowing
into the microphone).
Metering mode
Press "o.k." to tick it and
press menu key to switch
off the handset. Now you
can see radio parameters
during normal usage ***
*** example: 98 - 9 - 04 - 096 - 100
RX - Level
Frequency (0...9)
Time slot (0...11)
Base station code
bit error rate
100 = 100% o. k.