MTD 50MC Operator's Manual page 9

NOTE: Each end of the lower handle must be placed in the
same position on the mounting brackets.
a. Remove the star knobs shown in Fig. 3-3 and remove
the lower handle.
Figure 3-3
b. Position each handle bracket stud into the top hole
in the lower handle.
c. Tighten the star knobs.
3. Position the recoil starter by following the steps below:
a. Hold the blade control against the upper handle.
b. Slowly pull the starter rope out of the engine. See
Fig. 3-4.
C
Figure 3-4
c. Slip the starter rope into the rope guide.
d. Tighten the rope guide wing nut.
A
B
D
4. Use the cable tie provided to secure cable to the lower
handle. Pull the cable tie tight and trim excess. See Fig. 3-5.
Figure 3-5
Rear Wheels
Install rear wheels as follows in Fig. 3-6 (wheels maybe already
installed at factory, if so disregard this step):
Figure 3-6
1. Place rear of the mower deck on raised blocks.
2. Remove lock nut from pivot arm assembly (on select
models, these may be included separately in a plastic bag).
3. Slide wheel, with hollow side in, onto pivot arm and secure
with lock nut.
4. Assemble the other side in the same manner.
s
ectiOn
3 — a & s -u
sseMbly et p
9