Preparing For Tv Sound - Sony MHC-GT5D Operating Instructions Manual

Preparing for TV sound

You can listen to the TV sound through this system by connecting the
subwoofer and the TV as shown below, using the optical digital cable
(supplied).
To listen to the TV sound with an optical digital connection
Turn on the TV, and then press FUNCTION +/– repeatedly to select the optical
function.
Note
The system may enter standby mode automatically if the volume level of the connected
TV is too low. Adjust the volume level of the TV. If you turn off automatic standby function,
see "Setting the automatic standby function" (page 67).
Hints
You can also connect external equipment (DVD players, etc.) to the OPT IN jack. When
• •
connecting such equipment, connect the OPT IN jack and the Digital Out (Optical)
jack of the equipment in the same manner as shown above. For details, refer to the
operating instructions of your equipment.
If the audio output level from the system is low when connecting the external
• •
equipment, try adjusting the audio output settings on the connected equipment. It may
improve the audio output level. For details, refer to the operating instructions of your
equipment.
If "CODE 01" and "SIGNAL ERR" appear on the display of the
subwoofer
When the audio input signals to the system are other than 2-channel
Linear PCM signals, the messages "CODE 01" and "SIGNAL ERR" (indicate
that the input audio signals are unsupported) appear on the display of the
subwoofer.
In this case, select the proper audio output mode on the TV or external
equipment in order to output 2-channel Linear PCM audio signals.
Optical digital cable
(supplied)
Digital Out
(Optical) jack
TV
27
GB