Draytek Vigor2600 Quick Start Manual page 12

Install ' Router
Tools '
Turn on your router
Connect to
Router
Password
This tool which provides 'Smart StartWizard', 'Firmware Upgrade Program'
and 'TFTP client' is in the attached CD. It supportsWindows, Mac OS 8/9 and
Mac OS X. Moreover, it provides "Syslog Tool" for Windows system. For
Vigor2600X and Vigor2600W models, there is vitual TA program for the usage of
ISDN AP.
Once all previous steps are completed, turn on your router. After Power is on,
the 'ACT' LED and corresponding LAN port LED will light.
If the LEDs do not light normally, please refer to section A, 'Trouble Shooting',
for furthur information.
If the PC is set to obtain IP address automatically (recommended), you can
useWindows winipcfg.exe or ipconfig.exe to check if it has obtained an IP address
from the router. If not, please reboot PC and ensure that it has obtained an IP address
from the router.
Then you can use 'Smart StartWizard' to configure router or connect to router
viaWeb browser directly. The default IP of router is 192.168.1.1.
The default password is null. You can press 'OK' to skip it.
12