Operation - DeWalt D25413-XE Manual

Quick Change SDS Chuck (Fig. 5)
(D25414-XE & D25415-XE ONLY)
The SDS chuck can be easily removed by
turning the collar (L) into the unlocked position
to release the chuck.
The SDS chuck can be easily attached by
inserting the chuck into the spindle of the tool
and turning the collar to the locked position.
The chuck will click when properly installed.
Inserting and Removing SDS Plus
Accessories (Fig. 1)
WARNING: Burn hazard. ALWAYS wear
gloves when changing bits. Accessible metal
parts on the tool and bits may get extremely
hot during operation. Small bits of broken material may damage bare hands.
WARNING: Do not attempt to tighten or loosen drill bits (or any other accessory)
by gripping the front part of the chuck and turning the tool on. Damage to the chuck
and personal injury may occur.
To insert bit, insert shank of bit about 19 mm (3/4"), no further than 7/8" (22 mm)
into chuck. Push and rotate bit until it locks in place. The bit will be securely held.
To release bit, pull the chuck (F) back and remove the bit.

OPERATION

WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Proper Hand Position (Fig. 6)
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand
position as shown in Figure 6.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
FIG. 5
L
®
Proper hand position requires one hand on the side handle (C), with the other hand on
the main handle (D).
FIG. 6
C
Depth Rod (Fig. 7)
(ONLY FOR D25413-XE, D25414-XE & D25415-XE)
TO ADJUST THE DEPTH ROD
1. Push in and hold the depth rod release button (E) on the side handle.
2. Move the depth rod (D) so the distance between the end of the rod and the end
of the bit equals the desired drilling depth.
3. Release the button to lock rod into position. When drilling with the depth rod, stop
when end of rod reaches surface of material.
FIG. 7
D
7
D
E