Heatilator CRAVE4836 Installation Manual page 51

2. The included media placement jig, shown in Figure
2, MUST be used any time media are placed on the
burner to ensure that none end up in the burner lighting
area. Verify that the media placement jig is correctly
installed in place in the appliance. See Figure 3.
WARNING
Delayed Ignition Risk
• Place media according to instructions.
• Do NOT place media in area in front of pilot
• Do NOT place media in a position that they may
fall into area in front of pilot.
• Do NOT use any media other than the media
supplied with this fi replace.
• Do NOT exceed one layer of media on base pan.
Fireplace will not function properly.
Delayed ignition may occur.
ROCK MEDIA PLACEMENT JIG
PILOT SHIELD
BURNER RAILS (2)
BURNER
Figure 2. Media Tray Components
3. The media placement jig must remain in place while
media is placed on the media tray and around the pilot
bracket.
MEDIA PLACEMENT JIG MEDIA
Figure 3. Media Placement Jig in Place
Heatilator • CRAVE4836, CRAVE4836ST, CRAVE6048, CRAVE6048ST Installation Manual • 2301-970 Rev. E • 8/14
MEDIA TRAY
PLACEMENT JIG
4. Place an even layer of media around the media tray as
shown in Figure 4. Figure 3 shows an outline of the
burner rails and the area in front of the pilot assembly.
5. Continue to place an even amount of media over the
entire media tray.
WARNING
Risk of Asphyxiation or Fumes.
• Place media according to instructions.
• Do NOT place media in area between glass and
fi rebox.
• Do NOT place media in a position that they may
fall into area between glass and fi rebox.
• Do NOT use any media other than the media
supplied with this fi replace.
Fireplace will not function properly.
Gas leak may occur.
SCREW SCREW
Figure 4. Media Placement Jig in Place
6. Remove the screw, noted in Figure 5, from the media
placement jig and carefully lift it out of the appliance.
Do not allow any pieces of media to fall into the area in
front of the pilot.
7. Place the round media set aside in Step 1 over the
pilot shield and areas uncovered by removing the
media placement jig. See Figure 4.
WARNING! Risk of Fire. DO NOT place media directly in
front of the pilot assembly.
MEDIA BETWEEN MEDIA BETWEEN
BURNER RAILS BURNER RAILS
51