Table of Contents
Advertisement
SECTION 7: LUBRICATION
WARNING:
doing any kind of work on the lawn mower.
Blade Control:
Lubricate the pivot points on the blade control handle and the brake cable at least once a
season with light oil. See Figure 4. The blade control must operate freely in both directions.
Wheels:
The wheels are equipped with sealed ball bearings and require no lubrication.
Engine:
Follow engine manual for lubrication instructions.
Axle Shaft:
One zerk fitting on each side (inside rear deck) of axle height adjuster for self propelled model
only.
SECTION 8: MAINTENANCE
WARNING:
or maintenance.
NOTE:
When tipping the unit, empty the fuel tank and keep engine, spark plug side up. Never tip the
mower more than 90 degrees and do not leave the mower tipped for any length of time. Oil can drain into the
upper part of the engine causing a starting problem.
ENGINE
Refer to the separate engine manual for all engine maintenance instructions.
• Maintain engine oil as instructed in the separate engine manual packed with your unit. Read and follow
instructions carefully.
• Poor engine performance and flooding usually indicates that the air cleaner should be serviced. To
service the air cleaner, refer to the separate engine manual packed with your unit.
• The spark plug should be cleaned and the gap reset once a season. Spark plug replacement is
recommended at the start of each mowing season; check engine manual for correct plug type and gap
specifications.
• Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean
to permit proper air circulation which is essential to engine performance and life. Be certain to remove
all grass, dirt and combustible debris from muffler area.
Always stop engine and disconnect spark plug wire before cleaning, lubricating or
Blade Control Handle
LUBRICATE
Axle Shafts
Wheels
Be sure to disconnect and ground the spark plug wire before performing any repairs
Engine
SEE ENGINE MANUAL
Figure 4
15
Advertisement
Table of Contents
