Volkswagen Marine TDI 100-5 User Manual page 75

Self-diagnosis
Function 05 – Delete fault code memory
The fault code memory can be deleted by
pressing the buttons 0 and 5.
It is only possible to delete the fault code memory
if it was checked beforehand.
Function 06 – End output
Communication with the engine control unit is
ended by pressing the buttons 0 and 6.
Ending communication by disconnecting the
diagnosis interface can cause temporary
malfunctions in the engine control unit and is
therefore not permitted.
Function 07 – Not used
Function 08 – Read measured value block
The engine operating data, e.g. current engine
temperature, can be read out with the diagnosis
system tester after pressing the button 0 and 8
and then entering a display group number.
The engine operating data are provided in
display groups. Refer to the Workshop Manual
for the list of display group numbers and the
values shown on the display.
Superior 75 Technology