Table of Contents
Advertisement
Water connection
– A tap with a 3/4 " male thread must
be provided on site.
– Connection to the mains water sup‐
ply should only be carried out by a
qualified and competent person in
strict accordance with national and
local safety regulations.
The tap should be easily accessible
once the appliance has been built in.
– The water pressure (flow pressure at
the take-off point) must be between
30 and 1000 kPa (0.3 and 10 bar). If
the water pressure is lower than this,
the fault message
appear in the display (see "Problem
solving guide"). If the water pressure
is too high, a pressure reducing valve
must be fitted.
88
will
Water intake
After connecting the dishwasher to
the water supply, check that all
plumbing connections are watertight.
To avoid any damage to the ap‐
pliance, the dishwasher must only be
connected to a fully vented plumbing
system.
The inlet hose must not be
shortened or damaged in any way as
it contains electrical components
(see illustration).
Hide quick links:
Advertisement
Table of Contents
