Fitting The Hob; Ventilation Requirements - CDA HCN510 Manual For Installation, Use And Maintenance

Fitting the Hob

Unpacking the hob:
Take care not to lose or mishandle any parts.
Fitting position of the hob:
This appliance must be installed a minimum of 50mm from any back wall and a minimum of 180mm away from any adjacent vertical
surfaces, e.g. a tall cupboard end panel. This may be reduced to 100mm if the adjacent surface is resistant to fire (tiles or steel, for
example). These dimensions are shown in Fig.6.

Ventilation requirements:

This appliance must be installed to allow air to flow freely to the air intake and from the air outlet. Failure to allow sufficient ventilation
could cause damage to the hob and constitutes incorrect installation, which is not covered by the warranty.
If fitting a cooker hood above the hob:
If a cooker hood is to be installed above the hob, the height of the hood above the hob must be at least 600mm (650mm is
recommended) (Fig.5). If the instructions supplied with the hood dictate that the hood must be installed at a height greater than
600mm, then that height is the minimum required.
Wall furniture requirements:
The minimum height of any cabinet immediately above the hob is 900mm. The minimum height of any adjacent units (including light
pelmets) is 400mm, unless they are manufactured from a material resistant to fire (steel, for example)
Notes:
ambient temperature.
as a pyrolytic programme on the oven.
sufficiently ventilated. In the event that this occurs, the zone display will show C. We recommend that you increase the ventilation
of the hob by creating an opening in the side of the cabinet (8 cm x 5 cm).
dusters or towels; this is to minimize the risk of the cooling system air intakes being obstructed.
If there are no vents provided in the plinth run, then a vent should be provided to ensure there is enough free air available for ventilation.
10